State PRG 40 NOMT Uživatelský manuál

Instruction Manual forResidential Manufactured HomeGas Water HeatersALL TECHNICAL AND WARRANTY QUESTIONS: SHOULD BE DIRECTED TO THE LOCAL DEALER FROMW

Installing the New Water Heater (cont’d)Temperature-Pressure Relief Valve10DISCHARGE PIPE(Do not cap or plug.Must terminatebeneathmanufactured home.)T

Installing the New Water Heater (cont’d)The combustion and ventilation air flow must not be obstructed.All vent gases must be completely vented to the

A gas line of sufficient size must be run to the water heater.Consult the current edition of National Fuel Gas Code ANSIZ223.1, also referred to as NF

Installing the New Water Heater (cont’d)13“Fuel” Conversion InstructionsFrom Natural Gas To Propane(L.P.) GasRead and follow detailed conversion instr

“Fuel” Conversion InstructionsFrom Natural Gas To Propane(L.P.) Gas (cont’d)Step 21. Replace the outer door if not replaced in step 17.Step 22. Remov

Installation ChecklistBEFORE LIGHTING THE PILOT:1. Check the gas lines for leaks.a. Use a soapy water solution. DO NOT test forgas leaks using a match

Lighting and operating instructions are located on front ofthe water heater, above or to one side of the gas controlvalve.CHECK FOR LEAKSBe sure to ch

Lighting (cont’d)FOR YOUR SAFETY READ BEFORE LIGHTINGWARNINGIf you do not follow these instructions exactly, a fire or explosionmay result causing pro

18Due to the nature of the typical gas water heater, thewater temperature in certain situations may vary up to30°F higher or lower at the point of use

Start Up ConditionsDRAFT HOOD OPERATIONCheck draft hood operation by performing a worst casedepressurization of the building. With all doors and wind

General Safety2WARNINGThis water heater has been factory equipped to operate withthe type gas indicated in the “EQUIPPED FOR” area of the rat-ing plat

HIGH TEMPERATURE SHUT OFF SYSTEMThis water heater is equipped with an automatic gas shutoff system. The high temperature shut off is built into thegas

Burner CleaningIn the event your burner needs cleaning, use the follow-ing instructions:If inspection of the burner shows that cleaning is required,tu

Temperature-Pressure ReliefValve OperationThe temperature-pressure relief valve must be manuallyoperated at least once a year.Periodic Maintenance (co

Use this guide to check a “Leaking” water heater. Manysuspected “Leakers” are not leaking tanks. Often thesource of the water can be found and correct

Repair Parts181218171612133414KEYNO. PART DESCRIPTION1 Temperature-Pressure Relief Valve2 Primary Anode Rod3 Drain Valve*4 Drain Valve Washer (17⁄32″

General Safety (cont’d)3WARNINGThis water heater must not be installed directly on carpeting.Carpeting must be protected by a metal or wood panel bene

General Safety...2,3Table

referred to as NFPA 54. This publication is availablefrom your local government or public library or gascompany or by writing NFPA, Batterymarch Park,

Typical Installation NOTE: To protect against untimely corrosion of hot andcold water fittings, it is strongly recommended that di-elec-tric unions or

Facts to Consider About theLocationThis manufactured home gas-fired water heater is for usein a manufactured home.You should carefully choose anindoor

83. The location selection must provide adequate clear-ances for servicing and proper operation of the waterheater.Locating the New Water Heater (cont

If a water heater is installed in a closed water supply sys-tem; such as one having a back-flow preventer, checkvalve, water meter with a check valve,